7
(2)Press OPERATION MODE SELECTOR button several
times and select “ ”.
(This operation is only available during dry operation.)
ON/OFF
Press ON/OFF button.
OPERATING INDICATOR lamp lights up or goes off and the
system starts or stops OPERATION.
NOTE
• Do not turn off power immediately after the unit stops. Then,
wait no less than 5 minutes.
Water is leaking or there is something else wrong with the unit.
[EXPLANATION OF HEATING OPERATION]
DEFROST OPERATION
• As the frost on the coil of an outdoor unit increase, heating
effect decreases and the system goes into DEFROST
OPERATION.
• The fan operation stops and the DEFROST lamp of the
indoor unit goes on.
• After 6 to 8 minutes (maximum 10 minutes) of DEFROST
OPERATION, the system returns to HEATING OPERATION.
Heating capacity & Outdoor air temperature
• Heating capacity drops as outdoor air temperature lowers.
If feeling cold, use another heater at the same time as this air
conditioner.
• Hot air is circulated to warm the room. It will take some time
from when the air conditioner is first started until the entire
room becomes warm. The internal fan automatically turns at
low speed until the air conditioner reaches a certain temper-
ature on the inside. In this situation, all you can do is wait.
• If hot air accumulates on the ceiling and feet are left feeling
cold, it is recommended to use a circulator. For details, con-
tact the place of purchase.
For programming TEMPERATURE, FAN SPEED and AIR
FLOW DIRECTION, follow the procedure shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and program
the setting temperature.
Each time this button is pressed, setting tempera-
ture rises 1°F.
Each time this button is pressed, setting tempera-
ture lowers 1°F.
In case of automatic operation
Each time this button is pressed, setting tempera-
ture shifts to “H” side.
Each time this button is pressed, setting tempera-
ture shifts to “L” side.
[°F]
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote controller is
60°F to 90°F.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan speed in order to
protect the unit.
AIR FLOW DIRECTION ADJUST
Press the AIR FLOW DIRECTION ADJUST button to
adjust the air flow angle.
• The movable limit of the blade is changeable.
Contact your dealer for details.
Press the AIR FLOW DIRECTION ADJUST button to
select the air direction as shown below.
DISPLAY appears and the air flow direction contin-
uously varies. (Automatic swing setting)
Press AIR FLOW DIRECTION ADJUST button to
select the air direction of your choice.
DISPLAY vanishes and the air flow direction is
fixed. (Fixed air flow direction setting)
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, the microchip controls the air flow
direction so it may be different from the display.
ADJUSTMENT
ON OFF
2
DOWN
UP
DOWN
UP
DOWN
UP
H • M • L
Setting temperature 77 73 71 70 66
FAN
SWING
Up and down adjustment
(255 Seiten)
(174 Seiten)
(21 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern