6
How to put the dry cell batteries
(1)Remove the back cover of the remote
controller to the direction pointed by
the arrow mark.
(2)Put the dry cell batteries.
Use two LR03<AM4> dry cell batter-
ies. Put the dry cell batteries correctly
to fit their (+) and (–).
(3)Close the back cover as before.
When to change batteries
Under normal use, batteries last about 1 year. However, change
them whenever the indoor unit doesn’t respond or responds
slowly to commands, or if the display becomes dark.
CAUTION
• Replace all batteries at the same time, do not use new and
old batteries intermixed.
• In case the remote controller is not used for a long time take
out all batteries in order to prevent liquid leak of the battery.
IN THE CASE OF CENTRALIZED CONTROL SYSTEM
If the indoor unit is under centralized control, it is necessary to
switch the remote controller’s setting.
In this case, contact your dealer.
• Contact your dealer to confirm your system type.
• To protect the unit, turn on the main power switch 6 hours
before operation.
• If the main power supply is turned off during operation, oper-
ation will restart automatically after the power turns back on
again.
Operate in the following order.
• AUTOMATIC OPERATION can be selected only by Heat
pump system or Heat recovery system.
〈〈FOR SYSTEMS WITHOUT COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH
(Fig. 1-1~2 on page 3)〉〉
OPERATION MODE SELECTOR
Press OPERATION MODE SELECTOR button several
times and select the OPERATION MODE of your
choice as follows.
COOLING OPERATION ................................................ “ ”
HEATING OPERATION ................................................. “ ”
AUTOMATIC OPERATION ............................................ “ ”
• In this operation mode, COOL/HEAT changeover is auto-
matically conducted.
• For VRV system, “ ” is not installed.
FAN OPERATION.......................................................... “ ”
DRY OPERATION ......................................................... “ ”
• The function of this program is to decrease the humidity in
your room with the minimum temperature decrease.
• The microchip automatically determines TEMPERATURE
and FAN SPEED.
• This system does not go into operation if the room temper-
ature is below 60°F.
ON/OFF
Press ON/OFF button.
OPERATING INDICATOR lamp lights up or goes off and the
system starts or stops OPERATION.
NOTE
• Do not turn off power immediately after the unit stops. Then,
wait no less than 5 minutes.
Water is leaking or there is something else wrong with the unit.
〈〈FOR SYSTEMS WITH COOL/HEAT CHANGEOVER
REMOTE CONTROL SWITCH (Fig. 2 on page 3)〉〉
OPERATION MODE SELECTOR
(1)Select OPERATION MODE with the COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH as follows.
COOLING OPERATION .............................................“ ”
HEATING OPERATION ...............................................“ ”
FAN OPERATION..................................................“ ”
DRY OPERATION ..................................................... “ ”
• See “FOR SYSTEM WITHOUT COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH” for details
on dry operation.
4. OPERATION PROCEDURE
COOLING, HEATING, AUTOMATIC, FAN, AND PRO-
GRAM DRY OPERATION
Placing the remote
controller
Slide from above.
Remote
controller
holder
Removing the
remote controller
Pull it upward.
MODE
1
ON OFF
2
1
(255 Seiten)
(174 Seiten)
(21 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern